Are Anti-Tip Brackets Required on Ranges?
By Rueben Saltzman of Construction Tech Home Inspections
This question comes from another home inspector: "Where can I find the requirement for an anti-tip bracket on a range?"
Before I answer that question, I ameliorate explain what an anti-tip bracket is. In short, it'south an aptly-named device that keeps a range from tipping over. Information technology's about what you lot might imagine, and they come in a few dissimilar styles. Hither's ane of them:
Do nosotros really demand these?
Anti-tip brackets are safe devices that started showing up in the late 1980s and became required past appliance manufacturers in 1991. Co-ordinate to the Consumer Product Safety Commission, there were 38 fatalities associated with ranges tipping over between 1980 and 2008. Over half of those involved children between the ages of one and 5 years onetime. The other big historic period group was elderly adults using the open up range door for support.
Side annotation: anti-tip brackets may also help to protect young adults who boldly use their range as a slice of playground equipment
This is something that many home inspectors check for and recommend adding if not nowadays. The CPSC has a prissy little sheet explaining how to bank check for the presence and proper installation of an anti-tip bracket: https://www.cpsc.gov/PageFiles/118037/5007tips.pdf. I find a lot of missing brackets, even in new construction homes. The anti-tip bracket pictured below was attached to the drywall only, which won't do any good.
Whoever drove that screw into the drywall knew they didn't hit anything, and their GaS level was clearly at about nothing. I'd prefer to run across no attempt even fabricated, and I certainly encounter that a lot. The picture below shows a new range with the anti-tip bracket still sitting in its original packaging.
And then back to question: are these required?
Equally I mentioned earlier, anti-tip brackets are required by manufacturers, but does this mean that they're required past the building lawmaking? Indirectly, yep. If nosotros turn to chapter 3 of the Minnesota Mechanical Lawmaking, we can find the following text under section 304.i:
304.i General. Equipment and appliances shall exist installed as required past the terms of their blessing, in accordance with
the atmospheric condition of the listing, the manufacturer's installation instructions and this code. Manufacturer'southward installation instructions shall be available on the job site at the time of inspection.
So there you have it. While the code doesn't specifically say that anti-tip brackets are required, it says you need to follow the manufacturer's installation instructions. If a manufacturer requires something equally office of their installation instructions, it becomes a code requirement past extension.
Source: https://www.familyhandyman.com/article/are-anti-tip-brackets-required-on-ranges/
0 Response to "Are Anti-Tip Brackets Required on Ranges?"
ارسال یک نظر